How To Install Garage Door Openers the old door of the garage should be first removed using the instructions in the manufacturer’s manual, this is undertaken by unlatching the door from its pulley system, before unscrewing the tracks, the door panels are set apart, one panel is removed at a time so that it does not fall on someone measurement of the areas where the door is to be installed first takes place, these areas include the door opening height and width, the headroom and the back room, after measurement, to both sides of the opening, stops are attached, they should flush with the inside edge of the door jamb, the bottom piece of the new door is then laid out using sawhorses, additionally weather stripping may be attached, hinges attached and handles lifted to piece Next, using a level in order to set the piece properly, the bottom piece is inserted into the frame of the door, after the piece is set in place, the tap nails partway into each jamb, the nails are bent slightly or slant so that they are secure in place, then using the manufacturer’s instruction, the vertical, curved and horizontal pieces of the track are assembled and then set aside The second panel is then installed on top of the first one, nails are then hammered into the side jambs so that they are well held in place, hinges are the next installed, then the process is repeated according to the number of panels that are necessary, however, it is a requirement that each of the pieces is anchored into the door jamb, this marks the completion of the fourth step undertaken when installing a garage door
Lessons Learned About Services
after securing all sections, rollers are then installed in the section that does support them after which they are placed in the assembled track, as one goes along the brackets of the tracks are secured, the rollers should not be pressed too tightly against the track to avoid friction which damages the door during usage
What No One Knows About Repairs
after securing the vertical tracks against the jambs, the horizontal and curved pieces are installed next, previous measurements are used during installation of the horizontal pieces, the tracks should be straight and point 90 degrees away from the opening, springs are then assembled according to manufacturer’s instructions, in order to make the tracks level and parallel, the door is lifted to about half length, in order to attach springs to the pulley, the door is lifted up the remaining distance, that is how a new garage door is opened